• Test

    From Gord Hannah@1:17/23 to All on Sat Jan 8 20:52:20 2011
    Hello, All!

    This is a seed message.

    Written on 08 Jan 11 at 20:52 MST

    We are fine Board trying to make it better.
    Hope this helps. Keep us posted.

    ghannah@pris.bc.ca
    Cheers!
    Gord
    --- Golded-NSF LNX 1.1.5
    * Origin: Marsh BBS(c) Dawson Creek BC,Canada (1:17/23)
  • From bill swisher@1:124/311 to Gord Hannah on Tue Jan 18 17:33:24 2011
    On 1/8/2011 7:59 PM, Gord Hannah wrote:

    This is a seed message.

    Hi ya Gord!

    Bill, who used to run The LitterBox and is married to one of the
    moderators of yore for dis joint.

    MMMMM----- Recipe via Meal-Master (tm) v8.05

    Title: Beaver Information [Canada]
    Categories: Information, Game
    Yield: 1 Info file

    INFORMATION

    The industrious beaver is the largest rodent on the North American
    Continent, and is found in all the waterways of the forested areas of
    the north. Its rich brown fur has long been prized by trappers and
    hunters, and the search for beaver pelts instigated much of the early
    exploration of the continent. Because of its contribution to the
    development of our Dominion, the beaver has been chosen as an emblem
    of Canada.

    If the beaver pelt is to be prepared for market, care should be taken
    in skinning the animal. Lay the beaver on its back in a clean place
    and cut off the legs at the first joints. Then, with a sharp knife,
    slit the pelt, starting at the lower lip. Insert the knife in this
    slit and, with the sharp edge up, cut the pelt in a straight line
    down the belly to the vent. Work out from this center line cut and,
    with short strokes,, separate the skin from the flesh. Carefully pull
    the legs through the skin, leaving four round holes in the pelt. Cut
    off the tail where it meets the fur. Skin carefully around the eyes
    and cut the ears close to the skull. Finish removing the pelt, taking
    as little flesh and fat with it as possible, then lay it on a flat
    surface, fur side down, and sponge off all the blood marks with
    lukewarm water. Complete directions for stretching and cleaning pelts
    are available from the Game Management Officers.

    Beaver meat is dark red, fine grained, moist and tender, and when
    properly prepared, is similar in flavor to roast pork. Cut the head
    from the carcass and eviscerate the animal as follows: Make a cut
    through the thin layer of meat from the breastbone to the vent,
    encircling the vent, and being careful not to puncture the
    intestines. Lay the body cavity open, and remove the viscera by
    grasping them above the stomach and pulling down and out from the
    body cavity. Carefully cut out the tiny musk glands from under the
    skin on the insides of the legs and be sure to remove the castor
    gland under the belly near the tail. Trim off all the fat, then wash
    the carcass thoroughly with warm water.

    From "Northern Cookbook" edited by Eleanor Ellis, Indian Affairs and
    Northern Development, Ottawa 1973. Typos by Bert Christensen

    MMMMM
    --- Platinum Xpress/Win/WINServer v3.0pr5a
    * Origin: FidoTel & QWK on the Web! www.fidotel.com (1:124/311)
  • From Gord Hannah@1:17/23 to bill swisher on Wed Jan 19 09:34:31 2011
    Replying to a message from bill swisher 1:124/311 to Gord Hannah,

    About Re: Test, On Tue Jan 18 2011

    Hi ya Gord!

    Bill, who used to run The LitterBox and is married to one of the moderators of yore for dis joint.

    Great, I was testing out a new system.

    Hope this helps. Keep us posted.

    We are a fine board trying to make it better.
    http://www.pris.bc.ca/ghannah
    ghannah@pris.bc.ca
    Cheers! Gord
    -=Team OS/2=-
    --- timEd/2 1.10.y2k+
    * Origin: Marsh BBS (c), Dawson Creek, BC Canada (1:17/23)
  • From bill swisher@1:124/311 to Gord Hannah on Wed Jan 19 16:12:50 2011
    On 1/19/2011 8:34 AM, Gord Hannah wrote:

    * Origin: Marsh BBS (c), Dawson Creek, BC Canada (1:17/23)

    Drove through there...spring of 06, fall of 06, spring of 07, fall of
    07, and spring of 08. Got as close as Prince George the summer of 1980
    when we moved to Anchorage, and twice in 1972 (or so, it was spring/fall
    the year of the great Arab oil embargo) while traveling to/fro from
    Ketchikan via Prince Rupert when I worked on a seine boat.

    Landed there once on a Condor flight from Frankfurt to Anchorage, fall
    of 1999...oh wait...the flight landed at Whitehorse...never mind...but
    they have a neat "wind sock". :-)
    --- Platinum Xpress/Win/WINServer v3.0pr5a
    * Origin: FidoTel & QWK on the Web! www.fidotel.com (1:124/311)
  • From Gord Hannah@1:17/23 to bill swisher on Thu Jan 20 09:56:48 2011
    Hello, bill!

    19 Jan 11 16:12, from bill swisher -> Gord Hannah, in URL area://ALASKA_CHAT?msgid=1:124/311+ca3d3ac6:

    Drove through there...spring of 06, fall of 06, spring of 07, fall of
    07, and spring of 08. Got as close as Prince George the summer of
    1980 when we moved to Anchorage, and twice in 1972 (or so, it was spring/fall the year of the great Arab oil embargo) while traveling
    to/fro from Ketchikan via Prince Rupert when I worked on a seine boat.

    Good to see that you were out on the road abit, Dawson Creek is indeed changing, growing, and getting a bit busier even with the recession.


    Written on 20 Jan 11 at 09:56 MST

    We are fine Board trying to make it better.
    Hope this helps. Keep us posted.

    ghannah@pris.bc.ca
    Cheers!
    Gord
    --- Golded-NSF LNX 1.1.5
    * Origin: Marsh BBS(c) Dawson Creek BC,Canada (1:17/23)